Culligan Water Softeners
in Brighton, MI

No. A softener that’s set up correctly won’t make your water taste salty. Brighton’s water already carries about 44 ppm of sodium before it’s softened, so if you’re limiting sodium, ask about potassium chloride instead of salt, or add a reverse osmosis system at the kitchen sink.

Hard water leaves white crust on faucets and showerheads, a film on glassware, soap that won’t lather well, and scale inside water heaters and dishwashers. At 25 to 27 grains per gallon, Brighton’s city water sits far above the point where most households start to notice these signs.

City water is listed at 25 to 27 grains per gallon, so a softener on city service has to be sized and programmed for very hard water. Iron, household size, and daily water use all change the right setting. Homes on private wells in Brighton, Genoa, or Green Oak Township can test very differently from city water, so a Culligan water test is the best way to set your softener correctly.

A water softener uses a process called “ion exchange.” As water passes through the resin, calcium and magnesium (the minerals that make water “hard”) are swapped one for one, usually for sodium. The amount added depends on how hard your water is, and in most homes it is not a significant part of daily sodium intake.

A softener can remove a small amount of dissolved iron along with hardness. The city filters iron out before water enters the mains, and its report doesn’t list an iron level for finished water. Private wells in the surrounding townships skip that step, and iron often arrives with the hardness. In those homes, pairing a softener with whole house filtration protects the resin and prevents rust-colored stains.

Yes. If hard water has been building up scale in your appliances, a softener will gradually begin to dissolve that buildup once it’s installed. It takes time, but the scale does come off.

No. A water softener is built to remove hardness. For drinking and cooking water, Brighton homeowners who want to reduce sodium, copper from household plumbing, and other dissolved minerals should consider reverse osmosis.

Other than salt or potassium chloride, a water softener doesn’t use any chemicals. Soft water also means you need less soap, detergent, and cleaning product, so less of it goes down the drain.

Your softener starts working right away. If you have a tank-type water heater, it may take a few days to flush out the hard water already stored inside before you feel the full effect.

Modern Culligan softeners regenerate based on how much water you use and how hard it is, so homes with water as hard as Brighton’s go through more salt than homes with softer water. Culligan can deliver salt on a schedule, so you never have to haul bags.

Yes. A Culligan water softener rental includes professional installation, maintenance, and support, with no large upfront cost.